Thanks very much for the tip, It's very clean and shiny, just wanted to be safeIf it's off the 'bay, or similar then best bet is to get barbicide (or generic germicide) and follow the instructions. Usually 6% germicide to water volume. Leave it soak and you're done. Toothbrush and hot water with washing up liquid to remove any gunk worked for me too.
Also good form if you're participating in any of the pass arounds to treat them before moving on. Do not use Milton - that stuff can mess with metal and damage your razor irreversibly.
Flare Tip.Hi Everyone
I just managed to get an old Gilette flair tip. What is the best was to sanitise it. It is in great condition, Can I use Milton? or just boiling water? What do you guys do? -Any help and tips would be appreciated, Thanks guys
cheers
D
"The recommended dilution is 30ml of Milton (liquid) - 5l cold water,i have been doing mine with milton tablets for a long time with no adverse effect however after jesters comments i will definitely stop using milton
Was that some of that stainless steel crap? Never clean SS with bleach, or bare steel either.View attachment 68288
The above post is lifted from a previous Barbicide discussion on this forum. Milton is obviously a dilute bleach solution
I boil mine in gasoline over an open flame.
That was a joke, just in case some dimweed actually wants to try it.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?