Hi guys I was cleaning up a couple of razors that I have and decided to Dremel them with the wire brush attachment.
I have found that it doesn’t take a lot to get a burn mark in the razor when trying to clean out rust so I tried an experiment and used Solvol Autosol as a polish/lubricant and it seemed to work fine for me.
It also helped when going between the scales at the tang as I could see where the brush was touching as it was removing the polish. It also left quite a nice finish considering that it was a wire brush doing the work.
I was just wondering if anybody else had tried this.
Exile
I have found that it doesn’t take a lot to get a burn mark in the razor when trying to clean out rust so I tried an experiment and used Solvol Autosol as a polish/lubricant and it seemed to work fine for me.
It also helped when going between the scales at the tang as I could see where the brush was touching as it was removing the polish. It also left quite a nice finish considering that it was a wire brush doing the work.
I was just wondering if anybody else had tried this.
Exile