When I first set up my workshop I always planned on making razors but decided to 'get my eye in' by making a few knives. Several years later and I'm basically a professional knife maker and have never even attempted to make a razor! Time to stop messing about.
This slightly odd looking item is to be my prototype.
The rational being that the grinding and heat treating are the big challenges for me here and this design will allow me to practise both without spending time drilling pivot holes, tapering tangs etc only to destroy the thing in the oven.
It will be 22mm wide with the sharp bit measuring 70mm and the overall length being around 150mm. The grind will be something like a half hollow as I only have an eight inch contact wheel and I'll be using carbon steel for ease of heat treating and cost. I do have a rather large piece of RWL34 ready to go but it's expensive stuff so I going to hold onto it for now.
I'll update this thread as I go and hopefully we'll all learn something along the way. Even if it's that I should stick to knives
Any/all input is most welcome
This slightly odd looking item is to be my prototype.
The rational being that the grinding and heat treating are the big challenges for me here and this design will allow me to practise both without spending time drilling pivot holes, tapering tangs etc only to destroy the thing in the oven.
It will be 22mm wide with the sharp bit measuring 70mm and the overall length being around 150mm. The grind will be something like a half hollow as I only have an eight inch contact wheel and I'll be using carbon steel for ease of heat treating and cost. I do have a rather large piece of RWL34 ready to go but it's expensive stuff so I going to hold onto it for now.
I'll update this thread as I go and hopefully we'll all learn something along the way. Even if it's that I should stick to knives
Any/all input is most welcome