Hi this is my third set of scales this was different because I normal sharpen the razor after I have finished the restore this time this razor was in my rotation and one of my favourite razors to shave with. However it was affectionately called Mr Ugly in our house because it looked so bad the original scales had big lumps out of them and I didn’t do anything to them. However I made these scales and looked for a razor that I could put into them and my kids recommended Mr Ugly as a candidate. I made them using a block of acrylic cut into 3mm strips with a hack saw then machined them flat using my drill press and a milling bit. I then filed the edges to a 45 degree angle and left all the corners square when I had done this I was looking at the pins and thought that round washers would look funny so I filed them square and made sure that the pin was rounded over more than usual to make the washer look the right size. Anyhow this is one of my favourite razors and now I think that it looks ok.