- Joined
- Tuesday February 8, 2011
OK I would like to show you how to make a practical and functional razor holder, first get yourself a Ikea stainless steel desert fork, then carefully remove 20mm from the handle, and round the edges and 10mm from the prongs which also should be rounded, now remove the middle prong by drilling it out by placing the drill which should be the same diameter as the two existing outside prongs so you have a curved back for you razor to sit in, also slightly angle your two prongs upwards just at the end so you razor slightly tilts back bend the neck at a 90 degree angle, almost finished, now drill a small hole just up from the bottom of the handle so you can fit a small stainless steel screw through, drill wall and place where suitable. if you look at the photo's it's sometimes a better way of working it out.
Jamie.
Jamie.