You are going to need a few pieces of tape on that one in order to keep the bevel relatively small. The ratio of blade width to spine should be in the range of 3.5 to 4:1 - that's measuring from where the spine hits the hone. That gives an optimal bevel of around 18 degrees and in this case the spine looks to be right at the top so you have a ratio of 5.3 which will reduce the angle to less than 11 degrees.
Drop me a pm if you want to discuss scale materials etc.
Edit. If your tape is 0.5mm thick, three layers will give you somewhere near an 18 degree bevel.