- Messages
- 651
Perfect! Will definitely need to give this a go me thinks.Neither @Looney a spray of good old H2o holds it in place perfectly
No but it's a good price so give them a go mate.Perfect! Will definitely need to give this a go me thinks.
Film bought from here? https://www.workshopheaven.com/materials/workshop-supplies/abrasives/3m-lapping-film.html
Thanks Wayne I Might Take You Up on that..Cheers..I can get you some if you like. Let me know if you want a piece same size as a Naniwa with beveled edges. I'll sort it for you.
Oh Yeah.Just Feel the Difference with Say 30 Sets on 1 Micron Film Coming Off a Naniwa 12 K Super Stone..Its Night & Day..On that Note..Its Good to Feel the Edge with the Thumb After Every 20/30 Sets or So..That Way You Can Monitor the Sharpness..With Sheffield Steel for Example its Easy to Take them Towards Shavette Sharpness Levels..Too Much Gun So to Speak..
So the Learning Curve with 1 Micron Film is Not to Over Sharpen them & Find a Balance between Smooth & Sharp..A Very Sharp Edge on Softer Steel SRs can be Very Unforgiving..Razors Like Hard French or Japanese Steel for Example Excel on 1 Micron Film Maxed Out to 100 Sets or So & Keep a Smooth as Butter Shaving Edge..
Billy
There is About 3 Strips in Each Sheet..It Can Hone More than a Few Razors..Lapping Film Can Be Used Multiple Times..Oh Yeah..Lapping Film Can be Used as a Full Progression..15, 12, 9, 5, 3, 1 Micron...15 Micron Is Fine for Bevel Setting But it Gets the Most Wear..A Naniwa 1 K Stone is Preferable for Bevel Setting then 12, 9, 5, 3, 1 Micron Finish...You Can Finish on 3 Micron which is 12 K Grit..
Billy
Lapping Film is Great for Honing SRs..Its a Similar Edge to Naniwa Super Stones..I Would However Strongly Suggest a Naniwa 1 K Pro Stone for Bevel Setting..Around 90 % of the Learning Curve Learning to Hone SRs is On the 1 K Bevel Hone..
Once the Bevel Work is Done the Progression is More or Less a Formality & Lapping Film Works Well..
Billy
Ran a Freshly Honed Razor Over a 1 K for 50 Sets..Mmmm...Not Sure About that One..That's a Quick Ticket to Requiring a Re Hone Job..I Am Assuming You Meant 1 Micron..
Billy
Good job.I built a little base out of two pieces of the heavy plastic they use in hockey glass. Cut them off 3x8" with my dremel tool and superglued them together. Some little rubber feet I found in my junk drawer and a strip of duct tape around the outside edge until I can take it to the shop and grind off the rough edges, (that stuff is HARD) and it works great.
Agree, nice job. I have a big old granite tile, but no lapping film yet, it's been used to put wet and dry on to lap my stones so far!I built a little base out of two pieces of the heavy plastic they use in hockey glass. Cut them off 3x8" with my dremel tool and superglued them together. Some little rubber feet I found in my junk drawer and a strip of duct tape around the outside edge until I can take it to the shop and grind off the rough edges, (that stuff is HARD) and it works great.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?