You really only want about 1mm/1.5mm to peen, a cold chisel won't be that accurate, and it is a wee bit overkill, even cheap cutters should manage 1/16th brass rod without any problems....but they don't.Wouldn't a small cold chisel do the job if you finish the pin end with a small file?
Went for knipex at £24
Knipex are always reliable, and their plier/wrenches are superb.Went for knipex at £24
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?