Except if you wear glasses!!You have to stand side on to the mirror and look out of the corner of your eye.
I do.Except if you wear glasses!!
Will give it a go.I do.
Move in close. Corner of the eye. Line it up.
After the first stroke you should be fine.
Now I have a bit more time to reply, perhaps I can give you a more helpful answer.
You can often get away without skin stretching on the sideburns. In fact skin stretching can be counter productive because it can distort the line of the sideburn if you grab at an angle. That gives you more room below the glasses because you aren't pulling the skin upwards.
Worst case: once you have the razor positioned you don't even need to look for that stroke. (Just take it VERY lightly) Many a morning I've woken up bleary-eyed and not really looked whilst I was shaving... Until I got to my neck.
Secondly, if your second pass is across the face, as long as you have been maintaining the line of your sideburn consistently, you can keep it trimmed with this pass.
What type of shavette are you using? DE blade or Artists Club. If a DE blade, is it full or half blade type? If it is the full blade, I would strongly recommend the half instead - I like the Focus AL - they are nice and easy to handle in tricky areas like the side burn.
If it is an Artist Club or clone then you are in luck. A trick you can try with these is to straighten them out like a Japanese (kamisori) just for the side burns. That gives you more room to play. I wouldn't recommend that with a DE type shavette because you lose control and the blade skips. Trust me on this...
What's the deal with the straight razor you gave up on? Have you thought about sending it for honing? Can I help with any advice regarding that?
I think its the half blade type. It uses those little double edged blades, snapped in half.
I've developed a little workaround myself, which is to hold the blade upside down, that is, as if you were going to shave up, line it up that way and then flip the blade over while still in contact with the skin, and then shave down. I wonder what you think of that method, perhaps there's a danger you might accidently pull the blade in a slicing motion while flipping it over and cut yourself?
As for the straight razor, I actually did send it for honing, to a guy on a forum like this one (can't remember which one now) and it came back not any sharper than when I had sent it. I looked the guy up and he was a professional barber so I trusted him. To be fair it did pass the 'hanging hair test', but even I can get it that sharp. Is there a level of sharpness above that? I assume so, because it was just sharp enough to shave my cheeks and neck, but in the really tough growth areas each side of the mouth and down around the chin it really started to drag and gave me a rash the next day. When I was sharpening myself I was using a Belgian Blue whetstone, and then I tried the pasted strop method to try and get it a bit sharper, with not much success.
Just be careful when you flip the blade that you don't catch yourself. I would still experiment careful with positioning from the side.
I don't really trust the HHT as the final measure. There are a couple of problems with it. The blade might not be even all the way down the edge, for one. Therfore it might appear to cut hair but as soon as you start shaving it would drag from the sections that aren't consistent. Then there are degree by which it cuts the hanging hair and really you should be able to just touch the tops of your hairs. Not all HHTs are equal, at minimum the hairs should ping, at best they should fall off even from the top. Of course, if the blade doesn't treetop at all, then you know you have a problem. As a result I prefer to go by the feel and sound of the razor on the strop s the final test.
My father taught me to listen to the sound of the razor on a canvas strop. You can hear the pitch change when it's ready to go to the leather. If you don't hear that pitch change then the edge isn't right. I use a leather paddle strop maintained with strop balm. This creates a heavy draw. If the razor is ready to shave it will strop without too much pressure to keep it moving smoothly. If it isn't ready it will skip and jump on the strop of you don't apply pressure.
It's hard to quantify levels of Sharpness scientifically and I wouldn't want to mislead you. I have bought a fair few shave ready razors and they haven't been. Except from a couple of sources. Even then they have been improved through pasted stropping. YMMV
Is there a YouTube video or anything where I could hear this change in pitch?
What about the stone? Is the Belgian Blue sufficient or should I go to another stone?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?