DIY Brush stand ideas?

Sorry, never used a brush stand. If you shake and squeeze most of the water out then ‘strop’ the brush on a towel’ it should be fine as although water bends to gravity (alas, my poor gut), evaporation kinda goes up the way I finks.

No help as usual, that’s me…
 
1850664482_0dd189e926_n.jpg
 
Sorry, never used a brush stand. If you shake and squeeze most of the water out then ‘strop’ the brush on a towel’ it should be fine as although water bends to gravity (alas, my poor gut), evaporation kinda goes up the way I finks.

No help as usual, that’s me…
Brushes have a flat bottom for a reason, gravity plays no part is brush drying. Water wicks up into the bristles and evaporates regardless of brush orientation.
 
I made one big enough for 2 brushes out of a bamboo post-it note holder which I bought in Homebase for about £3. Used a hole cutter drill and a Dremel to finish. Works a treat even with the large Phantom Aerolite 26mm.
Just cut holes out of the "back wall" (in its intended orientation) and stand it on its front.

Edit. SKU 514571
12x12x7 cm HxWxD.

16300746943642834842076051660379.jpg1630074517794641133880670807742.jpg
 
Last edited:
Back
Top Bottom