Highlander brushes
- Thread starter gile
- Start Date
- Messages
- 3,823
- Location
- Edinburgh Scotland
Look Great mate.
Any Spares going i’ll happily take one of your hands.
OP
- Messages
- 1,111
- Thread Starter
- #755
I have some spare blanks so I can make something for you.
What synthetic knot is in this mate?
OP
- Messages
- 1,111
- Thread Starter
- #762
Oumo St1
I was perusing this thread enjoying the craftsmanship and appreciate how your attention to detail translates even in the videos you make.
What I mean by this is that you worked out where to start and how many turns so that when you flip the brush to showcase the bottom of the brush the logo always ends up being the correct side up.
A man of detail !!!
What I mean by this is that you worked out where to start and how many turns so that when you flip the brush to showcase the bottom of the brush the logo always ends up being the correct side up.
A man of detail !!!
OP
- Messages
- 1,111
- Thread Starter
- #764
Thank you for noticing that Dan. It was easier for me to make a short routine video that will showcase the whole brush and not being too long and make it somehow signature. It's just a few seconds job to align it properly for coin to be oriented properly.I was perusing this thread enjoying the craftsmanship and appreciate how your attention to detail translates even in the videos you make.
What I mean by this is that you worked out where to start and how many turns so that when you flip the brush to showcase the bottom of the brush the logo always ends up being the correct side up.
A man of detail !!!