- Joined
- Tuesday September 3, 2013
- Location
- Cambridgeshire, UK
So I received a new Black Beauty in the post today and started giving it a thorough clean because the "last 1/4 turn" was locked. The TTO mechanism was very stiff and creaky with 20+ years of scum and buildup.
Gave it a soak in boiled water from the kettle for about 15 min and the TTO was looser but you could tell the spring was still locked.
Put a few drops of detergent in the mug and refilled from the boiled kettle for a 30 min soak (water was cool when I pulled it out).
No change.
So then I flushed it with rubbing alcohol and sprayed a generous helping of WD-40 down the barrel, in the hole at the bottom, and in the adjustment barrel. This freed up a lot of the mechanism and got rid of the squeak but it also loosened the collet under the adjustment dial so this happened:
Turns out the TTO spring was "locked" because the adjustment dial was "under-clocked", meaning someone in the past had dialed the adjustment beyond the "1" into the nether-region. I figured this out when I saw the silo-doors touching the safety bar on the '1' setting.
So I used these instructions:
Now the adjustment dial & TTO operates smoothly and the spring engages for the "last 1/4 turn" movement.
Yes! Results!
Gave it a soak in boiled water from the kettle for about 15 min and the TTO was looser but you could tell the spring was still locked.
Put a few drops of detergent in the mug and refilled from the boiled kettle for a 30 min soak (water was cool when I pulled it out).
No change.
So then I flushed it with rubbing alcohol and sprayed a generous helping of WD-40 down the barrel, in the hole at the bottom, and in the adjustment barrel. This freed up a lot of the mechanism and got rid of the squeak but it also loosened the collet under the adjustment dial so this happened:
Turns out the TTO spring was "locked" because the adjustment dial was "under-clocked", meaning someone in the past had dialed the adjustment beyond the "1" into the nether-region. I figured this out when I saw the silo-doors touching the safety bar on the '1' setting.
So I used these instructions:
1. Lay the razor down so the spring is facing up. (the black/red thing in the rectangle.)
2. Turn the dial to 9.
3. Using a straightened paperclip, press in on the spring above the number nine.
4. While still holding the spring in, now try to turn it past the stop at 9 towards 1.
5. Once the dial is between 9 an 1 you can release the spring and then it should start clicking again once you reach 1.
Now the adjustment dial & TTO operates smoothly and the spring engages for the "last 1/4 turn" movement.
Yes! Results!